Setting sets for N5 BENCH PRESS - For setting staples on leather loops

DIE FOR SPECIAL PRESS FOR BELT CLIPS

This installation set fits on an N5 bench press to precisely and easily install staples ref. AGA08 on leather loops.

This tool is ideal for ensuring a professional finish to your creations.

Suitable for 4.7 x 8 mm staples.

The laying set is made up of two pieces:
- The lower part for placing the staple.
- The upper part to hold the loop.

Directions for use :
- Remove the base of your N5 press using a 5 mm Allen key.
- Raise the lower part of the installation set by approximately 5 mm. We recommend cutting pieces of leather and drilling a 12 mm diameter hole.
- Adjust the upper part of the installation game by adjusting its height so that it adapts to the thickness of your leather loop and hold it firmly during installation. The adjustment is made using the screw.
- Make sure to align the two parts of the installation set: the upper part must fit into the notches of the lower part.
- With this tool, you don't need to pre-drill your loop to install the staple.

Material: Steel

Dimensions :
- Base diameter (for the lower part): 12 mm
- Height of lower part (without base): 23 mm
- Screw diameter (for the upper part): 6.2 mm
- Height of the upper part (without the screw): 35 mm

This installation set only fits the N5 press . The other presses sold on our site are not high enough to accommodate the installation set.
Press and accessories sold separately
Made in Italy