Set of 50 BRASS rivets with T28 mating washers -7mm

50 BRASS RIVETS - T28 (#14) - SHANK DIAMETER: 2.8 MM

Assemble your parts using the peened rivet technique. Your creation will have an authentic look. This assembly technique is one of the oldest and also one of the most durable.

Material: Brass
Finish: Brass

Dimensions:

Head diameter: 9.5 mm
Shank diameter: 2.8 mm (T28)
Washer thickness: 1 mm
Washer diameter: 9 mm

Packaging: pack of 50

Two mounting methods:

Either with a T28 peening rivet setting tool, such as model ref. 8110-00:
- Make a 3 mm diameter hole in the parts to be assembled. Pass the rivet through the inside of your parts. Thread the washer, then tighten it with the setting tool. Cut off the excess with pliers, leaving approximately 2 mm of material. Begin peening using the concave part of the setting tool. Complete the assembly by peening the shank onto the washer with a hammer.
- The peening operation must be performed on a firm work surface; you can use an Ertalon plate to protect your support and the rivet head.
-> We recommend watching the video to learn how to set a peening rivet.

Or with the 3960-00 manual press and a T28 peening rivet setting die set (ref. 3984_00):
- Using a round punch, make a 3 mm hole in your leather.
- Insert part L into the lower part of the press.
- Insert part U-1 into the upper part of the press. Place the rivet head on part L, thread the leather, then the washer. Press the press lever to tighten the rivet with the washer.
- Using cutting pliers, cut off the excess shank, leaving approximately 2 mm.
- Insert part U-2 in place of part U-1. Press the press lever to peen the shank onto the washer.

Suitable for children over 10 years old
Made in USA for Tandy Leather